PRODUCTS

CY20A主图01CY20A主图02CY20A主图03CY20A主图04

CY20A

LCD solar charge controller

PDF File: CY20A controller
PRODUCT INTRODUCTION
The PR  series  charge controllers is the highlight in the range.

Use of the latest charging technologies combined with state of charge determination enable optimal battery maintenance and module power monitoring for up to 2880 Wp of connected power. A large display informs the user about all operating modes with the aid of symbols. The state of charge is represented visually in the form of a tank display. Data such as voltage, current and state of charge can also be displayed digitally as figures on the display..

Integrated data logger energy meter                       Automatic detection of voltage
PWM control                                                        Multistage charging technology
Automatic load reconnection                                  Temperature compensation
Overcharge protection                                           Deep discharge protection
Reverse polarity protection                                     Short circuit protection of load
Reverse current protection at night                         Load disconnection on battery overvoltage

INSTALLATION
Only install the regulator near the battery on a suitable surface. This surface should be solid, stabile, even, dry and nonflammable.
The battery cable should be as short as possible and have a suitable cable diameter size to minimize loss, e.g. 4 mm² at 20 A and  2m length.
Do not install the controller to direct sunlight.
If the solar battery will be operated under a large temperature range (winter/summer) the external temperature sensor should be used. A temperature compensated final charge voltage will extend the batteries lifetime and uses the optimum charge capacity.
To ensure the air confection on each side keep a distance of 10 cm to the regulator. The temperature at the installation site may never fall below or exceed the maximal permitted ambient temperature.
Connect the individual components to the symbols provided.
Observe the following connection sequence during commissioning:
1.  Connect the battery to the charge regulator - plus and minus
2. Connect the photovoltaic module to the charge regulator - plus and minus
3.  Connect the consumer to the charge regulator - plus and minus

The reverse order applies when deinstalling!
Please observe that the automatic adjustment to 12V/24V systems does not function properly,if this sequence order is not followed. An improper sequence order can damage the battery!
TECHNICAL DATASHEET

Model

2024

3024

2048

3048

Rated current

20A

30A

20A

30A

Rated voltage

12/24V

48V

Max solar voltage

<50V

<100V

Low voltage disconnect

10.7/21.4V

42.8V

Low voltage reconnect

12.6/25.2V

50.4V

Float charge

13.7/27.4V

54.8V

Standby loss

<20mA

Charging mode

PWM

Temp compensation

-4mV/Cell/℃

Opearating condition

-20℃~+60℃

Size/Weight

110*170*55/300g

*Product specifications are subject to change without prior notice

PREV:

NEXT:

Customer Service
Customer Serivce
© Copyright 2015~2024 Yueqing JYINS Electric Technology Co.,Ltd. All Rights Reserved.